Assembly mother and child hinge fixed end
The fixed end of the parent hinge is being installed, and the upper screw is tightened. The hinge of the mother and child is divided into a fixed end and a door end. The fixed end needs to be screwed before installation, and then the inner end angle wrench is used to fix the screw. Close to the ground or the wall.
Fixed mother hinge on the ground
Use a small internal angle to screw the screw. This is a fine work experience. After going through the procedure of confirming the position, punching and assembling, the next work is to install the fixed end on the ground and tighten it with the attached inner angle angle tool. The screws on the fixed end are automatically installed.
Confirm the position of the door terminal hinge
The hinge end of the door on the door can be screwed only. It is useless to install the fixed end of the hinge light. It is also necessary to install the door, and the key is to locate the door. The method is to open the door first. Maximize, then find the exact position on the door and screw the door terminal to the hinge.
Fine-tuning the mother hinge
Fine-tune the angle of the fixed end of the parent hinge and then fully tighten it. The final step of the hinge mounting is to fine-tune and rotate the angle of the hinge of the mother and child so that it fits all the door hinges. Finally, tighten the screws thoroughly.